CNH SDX Scraper Install Instructions

1. Position scraper on bracket tabs, hold bracket with tabs down and pointed away.

2. Place scraper on tabs with carbide down and pointed away.

3. 3/8“ hole in bracket and scraper should be in line.

4. Install 3/8 x 1 1/2” bolt thru hole with the bolt head on bracket side

5. Place spring on bolt with washer and secure with lock nut.

6. Remove opener depth gauge wheel and place bracket on round fitting where gauge wheel was bolted.

7. Place large washer outside of scraper bracket and re-install gauge wheel with bolt thru the bracket.